In this paper a composite prepreg manufactured using a relatively new high performance PAEK (polyaryletherketone) polymer from Victrex will be described, which offers out of autoclave (OoA) processing at lower temperatures than Polyetheretherketone (PEEK) and polyetherketoneketone (PEKK) whilst displaying excellent consolidation with minimal voids and good mechanical properties.
Coriolis Composites and Victrex teamed up to design an Automated Fibre Placement (AFP) process to unlock the potential of VICTREX AE™ 250 UDT. The results showed a significant increase in lay-up speed was possible whilst achieving industry acceptable levels of porosity (<2%) for in-situ consolidation. OoA consolidation showed the potential to reduce the cycle time and energy consumption.
This paper explores an innovative solution to eliminate waste and drive higher yields in consumer electronics using using VICTREX PEEK polymer and Husky's hot runner system.
The paper presents material behavior and the development of simulation methods for modeling a hybrid system. The results present test data and simulation results for both plaques and a bracket constructed using the hybrid molding technology.
VICTREX™ PAEK and PEEK polymers could be a good fit for critical components within the carbon capture, storage, and utilisation (CCUS) infrastructure with temperature, pressure, wear and chemical resistance, low permeability, and mechanical properties. This whitepaper explains why VICTREX PAEK polymers are suitable for CCUS, especially for sealing solutions such as in valves, seals, and compressor component applications.
This paper discusses the importance of looking beyond the minimum requirements of standard test protocols to better understand performance in harsh environments, and what data you should be asking for from your material or shapes suppliers.
The paper explores the benefits that VICTREX PEEK polymers can offer wind turbine wear components including brakes, roller bearing cages, and sliding bearings.
This paper outlines why 3D printing PEEK is challenging and how Victrex has developed new, easier to print PAEK polymers for filament fusion and laser sintering.